Lincoln Electric V350-PRO User Manual download pdf (Page 25)

CONNECTION OF THE LN-10 TO THE

V350-

PRO USING THE K1505 CONTROL CABLE.

NOTE: AN LN-10 CAN ONLY BE USED WITH A FAC-

TORY OR “CE” VERSION OF THE V350-PRO.

1. Remove input power to the V350-PRO.

2. Connect the K1505 control cable from the LN-10

to the Invertec 24/42VAC 14 pin amphenol con-

necter on the rear of the V350-PRO.

3. Connect the electrode cable to the output terminal

of polarity required by the electrode. Connect the

work lead to the other terminal.

4. Set the meter polarity switch on the front of the

V350-PRO to coincide with wire feeder polarity

used.

5. Set “CONTROL SELECT” to “REMOTE”.

6. Set the “MODE” to the “CV-WIRE” position..

7. Set the “WELD TERMINALS SELECT” to the

“REMOTE” position.

8. Set the “ARC CONTROL” to the “0” position and

then adjust to suit.

9. Set wire feed speed and voltage at the LN-10.

NOTE: The voltage set point displayed on the

V350-PRO should be ignored when operating in

the remote control mode with the LN-10.

10. See the LN-10 manual for details on accessing

the control DIP switch.

11. The control DIP switch inside the LN-10 should be

set as shown below for operation with the V350-

Pro.

Power Sources

ACCESSORIES

C-9 C-9

V350-PRO

Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC

Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC

+ -

14 PIN

AMPHENOL

TO LN-10

TO WORK

K1505

ELECTRODE CABLE

TO LN-10

(24/42VAC)

AT REAR OF

MACHINE

Figure C.8 LN-10 V350-PRO

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 154 155

Comments to this Manuals

No comments

Lincoln Electric V350-PRO User Manual Page 25

Comments to this Manuals

Related products and manuals for Welding System Lincoln Electric V350-PRO