Lincoln Electric Pro 100 User Manual download pdf (Page 10)

A-3

INSTALLATION

PRO 100

A-3

SELECT SUITABLE LOCATION

Locate the welder in a dry location where there is free

circulation of clean air into the louvers in the back and

out the front of the unit. A location that minimizes the

amount of smoke and dirt drawn into the rear louvers

reduces the chance of dirt accumulation that can block

air passages and cause overheating.

STACKING

PRO 100’s cannot be stacked.

TILTING

Each machine must be placed on a secure, level sur-

face, either directly or on a recommended undercar-

riage. The machine may topple over if this procedure

is not followed.

OUTPUT CONNECTIONS

Refer to Figure A.2.

1. Work Cable Access Hole.

2. Gun Cable and Control Lead Access Hole.

3. Connector Block.

4. Gun Trigger Lead Connectors.

5. Positive (+) and negative (–) output terminals.

PRO 100

DO NOT SWITCH

WHEN WELDING

3 6

FIGURE A.2

6. Wire Feed Gearbox.

7. Cable Hanger.

8. Thumbscrew.

Work Clamp Installation

Attach the work clamp per the following:

1. Unplug the machine or turn the power switch to the

“OFF” position.

2. Insert the work cable terminal lug with the larger

hole through the strain relief hole in the work clamp

as shown in Figure A-3.

3. Fasten securely with the bolt and nut provided.

FIGURE A.3

Strain Relief Hole

Nut & Bolt

Work Clamp

Work Cable

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 46 47

Comments to this Manuals

No comments

Lincoln Electric Pro 100 User Manual Page 10

Comments to this Manuals

Related products and manuals for Welding System Lincoln Electric Pro 100