Lincoln-electric SP-135 PLUS IM725 User Manual download pdf (Page 10)

A-3A-3

INSTALLATION

SP-135 PLUS

SELECT SUITABLE LOCATION

Locate the welder in a dry location where there is free

circulation of clean air into the louvers in the back and

out the front of the unit. A location that minimizes the

amount of smoke and dirt drawn into the rear louvers

reduces the chance of dirt accumulation that can block

air passages and cause overheating.

STACKING

SP-135 PLUS’ cannot be stacked.

TILTING

Each machine must be placed on a secure, level sur-

face, either directly or on a recommended undercar-

riage. The machine may topple over if this procedure

is not followed.

OUTPUT CONNECTIONS

Refer to Figure A.2.

1. Work Cable Access Hole.

2. Gun Cable and Control Lead Access Hole.

3. Connector Block.

4. Gun Trigger Lead Connectors.

5. Positive (+) and negative (–) output terminals.

6. Wire Feed Gearbox and Gun Connector Block

7. Cable Clamp

8. Thumbscrew - Secures gun and cable assembly

9. Optional Spot/Stitch Timer Kit see Accessories.

Work Clamp Installation

Attach the work clamp per the following:

1. Unplug the machine or turn the power switch to the

“OFF” position.

2. Insert the work cable terminal lug with the larger

hole through the strain relief hole in the work clamp

as shown in Figure A-3.

3. Fasten securely with the bolt and nut provided.

FIGURE A.3

SP-135 Plus

WELDING AMP RANGE

25-125

Work Cable Installation

Refer to Figure A.2.

1. Open the wire feed section door on the right side of

the SP-135 PLUS.

2. Pass the end of the work cable that has the termi-

nal lug with the smaller hole through the Work

Cable Access Hole (1) in the case front.

Strain Relief Hole

Nut & Bolt

Work Clamp

Work Cable

FIGURE A.2

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Comments to this Manuals

No comments

Lincoln-electric SP-135 PLUS IM725 User Manual Page 10

Comments to this Manuals

Related products and manuals for Tools Lincoln-electric SP-135 PLUS IM725