Lincoln-electric POWER MIGTM 200 IM693 User Manual download pdf (Page 10)

A-2

INSTALLATION

INPUT POWER, GROUNDING AND

CONNECTION DIAGRAMS

1. Before starting the installation, check with the local

power company if there is any question about

whether your power supply is adequate for the volt-

age, amperes, phase, and frequency specified on

the welder nameplate. Also be sure the planned

installation will meet the U.S. National Electrical

Code and local code requirements. This welder

may be operated from a single phase line or from

one phase of a two or three phase line.

2. Models that have multiple input voltages specified

on the nameplate (e.g. 208/230) are shipped con-

nected for the highest voltage. If the welder is to be

operated on lower voltage, it must be reconnected

according to the instructions in Figure A.1 for dual

voltage machines and Figure A.2 for triple voltage

machines.

Make certain that the input power is electrically

disconnected before removing the screw on the

reconnect panel access cover.

Read entire installation section before starting

installation.

SAFETY PRECAUTIONS

ELECTRIC SHOCK can kill.

• Only qualified personnel should perform

this installation.

• Only personnel that have read and under-

stood the POWER MIG 200 Operating

Manual should install and operate this

equipment.

• Machine must be grounded per any nation-

al, local or other applicable electrical

codes.

• The POWER MIG power switch is to be in

the OFF position when installing work

cable and gun and when connecting other

equipment.

WARNING

UNCRATING THE POWER MIG 200

Cut banding and lift off cardboard carton. Cut banding

holding the machine to the skid. Remove foam and

corrugated packing material. Untape accessories from

Gas Bottle Platform. Unscrew the two wood screws

(at the Gas Bottle Platform) holding the machine to

the skid. Roll the machine off the skid assembly.

LOCATION

Locate the welder in a dry location where there is free

circulation of clean air into the louvers in the back and

out the front. A location that minimizes the amount of

smoke and dirt drawn into the rear louvers reduces

the chance of dirt accumulation that can block air pas-

sages and cause overheating.

ELECTRIC SHOCK can kill.

• Do not touch electrically live parts such as

output terminals or internal wiring.

• All input power must be electrically dis-

connected before proceeding.

WARNING

POWER MIG 200

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments

Lincoln-electric POWER MIGTM 200 IM693 User Manual Page 10

Comments to this Manuals

Related products and manuals for Tools Lincoln-electric POWER MIGTM 200 IM693