Lincoln-electric POWER ARC 5000 User Manual download pdf (Page 11)

A-4

INSTALLATION

POWER ARC 5000

A-4

Assembly of Wheels and Handle to the

Tube Frame

Tools Required - Two 9/16 wrenches or sockets, 3/8 wrench

or socket and a rubber mallet or wooden

block.

Refer to Figure A-2 for illustration of proper assembly.

a.) Set the machine on blocks so that it is raised up off

the floor by approximately 6 inches.

b.) Install two of the vibration isolators (Item 1) to the

bottom of each foot (Item 2) using one each of the

supplied 3/8-16 X .875 hex head bolts and lock-

washers on each foot. (Detail A)

c.) Install the two feet to the alternator support channel

using three each of the supplied 3/8-16 X .875 hex

head bolts, lock-washers, and 3/8 - 16 hex nuts on

each foot. (Detail A)

d.) Install the two axle support brackets (Item 3) to the

engine support channel using two each of the

supplied 3/8-16 X .875 hex head bolts and lock-

washers, two each of the supplied 3/8-16 hex nuts,

two each of the large plain washers (spacers), and

two each of the vibration isolators (Item 1). The two

vibration isolators are installed in the inward holes

furthest from the tube frame. Refer to Figure A-2

Detail B. The two large washers must be installed

between the vibration isolators and the underside

of the channel. The remaining two large plain

washers (spacers)are not used.

e.) Install one of the push nuts (Item 4) on one end of

the axle (Item 5) by supporting the axle vertical and

tapping on the push nut with a rubber mallet or

wooden block.

f.) Install one wheel (Item 6) on to the axle and slide

the axle through the slots in the two axle support

brackets. The axle will rest on the two vibration iso-

lators when the machine is set on the ground pro-

viding a type of suspension for the axle.

g.) Install the other wheel and push nut on the other

end of the axle.

h.) Loosen but do not remove the four screws that

hold the handle clips (Item 7) to the fuel tank sup-

port channel on the alternator end. Install the han-

dle (Item 8) through the large holes in the channel

and tighten the screws that were previously loos-

ened. The height of the handle can be adjusted to

suit the user.

Alternator Support Channel

3/8-16 Hex Nut (3)

Lockwasher (3)

Lockwasher

3/8-16 x .875 Hex Bolt (3)

3/8-16 x .875 Hex Bolt

Rubber Isolator

Item 1

Foot

Item 2

3/8-16 x .875 Hex Bolt (2)

Lockwasher

Hex Nut

Wheel

Item 6

Push Nut

Item 4

Axle Support Bracket

Item 3

Axle

Item 5

Engine Support Channel

Rubber Isolator

Item 1

Large Plain Washer

(Spacer)

Tubular Frame

Figure A-2

Detail B

Detail A

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 49 50

Comments to this Manuals

No comments

Lincoln-electric POWER ARC 5000 User Manual Page 11

Comments to this Manuals

Related products and manuals for Tools Lincoln-electric POWER ARC 5000