Lincoln-electric LN-10 User Manual download pdf (Page 13)

A-6

INSTALLATION

LN-10

A-6

OPTIONAL FEATURES

INSTALLATION

Dual Procedure Switch Options

K683-1 Dual Procedure Switch (One per gun) -

Requires K686-2 Adapter for LN-10. Kit includes gun

switch, and mountings for Lincoln Innershield and

Magnum guns, with 15 ft. (4.5 m) control cable and 3-

pin plug. K686-2 Adapter permits 3-pin plug and 5-pin

gun trigger plug to be connected to LN-10 5-pin

Trigger/Dual Procedure receptacle.

Connect the 5-pin plug of the K686-2 Adapter to the

LN-10 Wire Feeder Trigger/Dual Procedure 5-socket

receptacle.

The 3-pin plug of the K683-1 Dual Procedure switch

connects to the 3-socket receptacle of the Adapter,

and the 5-pin plug of the welding un connects to the 5-

socket receptacle of the Adapter.

K683-3 Dual Procedure Switch Kit includes gun

switch, and mountings for Lincoln Innershield and

Magnum guns, with 15 ft. (4.5m) control cable and 5-

pin plug with two leads to connect to gun trigger.

Connect the 5-pin plug of the K683-3 Dual procedure

Switch to the LN-10 Wire Feeder Trigger/Dual

Procedure 5-socket receptacle.

The two lead plug cord extending out of the 5-pin plug

of the Dual Procedure switch is to be connected to the

two trigger leads of the welding gun per the instruc-

tions shipped with the kit.

K1449-1 Dual Procedure Remote Control

Provides remote rotating knob encoder control of Wire

Feed Speed and Voltage, along with a dual procedure

selector switch, when the remote control is connected

and REMOTE is selected by the LN-10 Procedure

key. The LN-10 A or B procedure light will also be on

to indicate which procedure is selected by the remote

control.

The 4-pin plug of the remote control connects to the

mating receptacle on the bottom of the LN-10 Control

box.

The K1450-”L” Extension cable is used to extend the

16 ft (5m) cable attached to the remote control.

Lengths “L” are available to match the Length of the

control to boom mount wire drive cable being used.

K1561-1 Robotics Interface Module - The module

plugs directly into the LN-10 control board and pro-

vides an interface to a properly equipped Fanuc robot.

When installed and properly configured, the K1561-1

Robotics Interface Module allows complete control of

the welding process from the robot controller.

The Lincoln Electric Companyʼs Automation Center

should be contacted for questions regarding installa-

tion or operation of the Robotics Interface Module.

All other options, see ACCESSORIES section, are

shipped with installation instructions.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Comments to this Manuals

No comments

Lincoln-electric LN-10 User Manual Page 13

Comments to this Manuals

Related products and manuals for Tools Lincoln-electric LN-10