Lincoln Electric KH825-01 Use and Care Manual

Browse online or download Use and Care Manual for Unknown Lincoln Electric KH825-01. Lincoln Electric KH825-01 Use and Care Manual User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
The Inferno Torch Instruction Manual
Page 1 of 2
Performance Data:
Maximum Supply Pressure - 170 PSIG
Minimum Operating Pressure - 17 PSIG
Maximum BTU - 500,000
Minimum Cylinder Size - 20 lbs.
Safety Precautions:
Read and understand all warnings and instructions before
attempting to operate the equipment. Never permit
children to use this torch.
Warning:
• Flames from this torch can cause serious burn
injuries to your skin and body.
• Blocking flame at torch head may cause flame
direction to reverse and exit from the top of the
torch head toward the operator.
• Using this torch on or near flammable material
or closed containers may cause a fire or explosion
which may cause injury or death.
• Failure to control burning material while using
this torch may cause injury or property damage.
Personal Protective Equipment:
• Always wear eye protection such as safety goggles or
glasses which meet ANSI Z87.1, heavy gloves, leather
shoes and heavy cotton clothing treated to be fire
retardant. Do not wear shorts or loose clothing.
Equipment Precautions:
• Only use this torch with propane gases from vapor
withdrawal cylinders. Do not attempt to use fuel gas other
than approved propane fuels.
• Propane cylinders must be kept in an upright position
especially when the torch is in use.• Before use, check all
equipment for leaks with an approved bubble solution. Do
not light torch until any and all leaks are repaired.
• Light torch only with an approved lighter (provided). Do
not use matches or a cigarette lighter.
• Do not permit lighted cigarettes, sparks or open flames
near this equipment.
• When not in use, close torch valve and cylinder valve.•
Do not abuse, tamper with or alter the operation of this
torch or its parts. Any repairs must be made by a qualified
repair technician.
Use of Equipment:
• When operating the torch, always have a helper with
proper NFPA approved fire extinguisher (or other fire
fighting apparatus) of a type and size appropriate for the
application and trained in its use nearby to watch and
control the burning material.
• Maintain secure footing when holding a lighted torch to
avoid falling. Shut torch and tank valves off if you are
moving more than a few yards.
• Always direct flame from the torch away from your body
when torch is lighted. Never point the torch at yourself or
other persons while lighting or operating. Keep other
persons away from the torch at all times.
• Never leave a lighted torch unattended. Turn the torch
valve off to extinguish the flame before laying the torch
down. Do not lay a hot torch down on or near flammable
material.
• Do not block the flow of air or fuel gas through the torch
head. Never allow the torch head to contact a surface or
block the flow of gas from the torch head. Doing this may
cause flame direction to reverse and exit from the top of
the torch head toward the operator. Lift torch head from
surface immediately if this occurs and release safety lever
valve.
• Do not use torch in areas where combustible gases or
vapors may be stored or otherwise present.
• Do not use this torch on or near flammable material or
sealed containers which may cause a fire or explosion
resulting in injury or death. Sealed containers, even if
empty, may explode.
• Only burn in a small area at one time. Do not use torch
near combustibles you do not intend to burn.
• Do not use the torch in windy or very dry conditions in
which the torch flame or the amount of material burning
may be difficult to control.
• In some locations you may not be permitted to burn
without a permit. Contact your local authorities and fire
department about state and local codes or permit
requirements before using torch.
• Torch head will remain hot for a time after shutdown.
DO NOT touch or store the equipment until it has cooled.
Warning:
Burning or heating some materials can produce
dangerous fumes which may cause injury to your
lungs or other parts of your body.
• Only use this equipment outside or, if inside, only
use for heating materials in a large area with enough
ventilation to avoid the build-up of smoke, fumes and
gases. If the air is not clear and free of smoke, fumes,
and gases, stop using the torch and move the work
outside or improve the ventilation.
• Propane fumes may collect in an unventilated or
enclosed area causing an explosive atmosphere or
one in which you cannot safely breathe.
• Never use the torch on materials, coatings, solvents
or chemicals which release toxic fumes when heated
or on plants such as poison ivy or poison oak.
• Avoid breathing smoke or fumes from burning
material.
• Keep your head out of the smoke or fumes.
• If the smoke or fumes make you uncomfortable,
stop using the torch on the material.
Warning: This product contains or produces a
chemical, including lead, known to the State of
California to cause cancer and birth defects (or other
reproductive harm). Wash hands after use.
(California Health and Safety Code 25249.5 et seq.)
For additional information regarding the safe use of
this product see the following reference publications:
NFPA/ANSI 58 - "Standard For The Storage and Handling
of Propane Gases" available from the National Fire
Protection Association ANSI/ASC Z49-1 - "Safety in
Welding and Cutting" available from the American
Welding Society CSA 2-94 - "U.S. Requirements for
Hand-Held LP Torches For Use With Fuel Supply"
available from the Canadian Standards Association
9500447  10/12
Page view 0
1 2

Summary of Contents

Page 1 - Maximum BTU - 500,000

The Inferno Torch Instruction Manual Page 1 of 2 Performance Data: Maximum Supply Pressure - 170 PSIG Minimum Operating Pressure - 17 PSIG Maximu

Page 2 - Page 2 of 2

The Inferno Torch Instruction Manual Page 2 of 2 Instructions: Set-up/Assembly Instructions 1. Close all valves on torch and tank. 2. Always inspec

Comments to this Manuals

No comments